How do you evaluate magnetic wireless charger stand stability before a bulk order? Put the largest or heaviest phone and case in your intended assortment on the sample, route the cable as a customer would, and check docking and removal on the intended desk surface. Record phone movement, angle drift and any sliding or lifting of the base separately.
Shinestone is an OEM/ODM wireless charger manufacturer and supplier. For a desktop 3-in-1 project, share the phones, cases, watch and earbud combinations you plan to support. Those details let the sample review focus on the product configuration that will go into your retail or distribution program.
Compare the layouts before measuring hold
Magnetic alignment helps position a supported phone over the charging area. The Wireless Power Consortium identifies it as a feature of Qi2. Evaluate desk stability and phone removal with your physical samples and check any required certification for the exact model separately. WPC overview of Qi wireless charging
| Published model | Catalogue layout | What to check on the sample |
|---|---|---|
| SST-WXC2642 | Rotating phone panel, watch arm and TWS earbud-case position on the base. Listed net weight 220 g. | Check clearance in each intended position. Observe whether the angle holds while using the phone and whether removing it turns the panel or moves the base. |
| SST-WXC2633 | Upright phone support, round base, side watch module and TWS position. Listed net weight 120 g. | Check whether the round base stays put during removal and whether the phone, watch and earbud case can each be reached with the other devices in place. |
The listed weights identify the products. Stability also depends on where weight is carried, the base contact surface and the direction of the user’s pull. Use the same phone, desk and removal motion when comparing the two samples.
Run four desk checks on the exact configuration
- Check seating and camera clearance. Identify the phone and case revision, then photograph the contact area. Check whether the case edge or camera bump changes how the phone sits. Dock it in each intended orientation and record whether charging starts reliably.
- Check movement during use. Set the stand on the intended surface with its supplied or quoted cable routed normally. Mark the base position and take a side reference photo. Use the phone in each supported position and record any base shift or change in angle.
- Try the intended one-hand release. Ask the supplier for the normal removal motion. Repeat it consistently, recording whether the phone releases cleanly, the stand lifts, the base slides or the rotating joint moves. If you compare pull force, document the fixture and direction alongside the result.
- Repeat with the other charging positions occupied. Fit the target watch and earbud case. Check that docking and removing the phone leaves both accessories accessible. Record mechanical interference and charging interruptions as separate observations.
Put the results in the sample approval record with phone and case, orientation, desk surface, cable route, release motion, observed movement and buyer decision. Agree acceptable movement and the number of repetitions before the comparison. Recheck affected conditions if the supplier changes the pads, housing, magnet assembly or joint. Wireless charger OEM change-control guide
Buyer questions
Does a higher pull force make a stand easier to use?
A higher pull force may improve retention in the tested direction. For a desktop stand, ease of use also depends on whether the base and joint stay in place during release. Compare both observations with the target phone and case.
Can portrait and landscape use share one result?
Check each orientation the buyer intends to advertise. Camera clearance, access to the watch arm and the motion used to remove the phone can differ.
What should be included in a sample request?
Send the model shortlist, exact devices and cases, intended positions, desk surface, quantity and destination market. Include the logo and packaging brief if you want those options reviewed with the sample.
Request an OEM/ODM stand sample
Ask Shinestone to review the stand layout and device combinations against your sample criteria. Confirm available configuration, branding, packaging and supply terms for the selected project. Request a sample or quotation
Magnetic 3-in-1 wireless charging stands · Wireless charger sample-testing checklist · Shinestone factory information
